Revolution 3D Printers INFINITY 3D Specifications download pdf (Page 19)

Revolution 3D Printers INFINITY 3D

8-Sep-14 19 19

Limit Switch Locations

Figure 11 Limit Switch Locations

Mechanical limit switches are strategically located to both aid in keeping the wiring

clean as well as to provide the least possibility of interference and trouble.

The X-Axis Limit switch is located on the X-Axis motor mount and is activated by

the tab on the aluminum extruder mount plate. This stop is not adjustable.

The Y-Axis Limit switch is located under the bed and is attached to the Linear

Bearing fitting on the LH back side, the stop located on the linear rod is adjustable.

Unlike the X and Y, the Z Axis Limit is an optical switch to provide extremely

accurate and repeatable limit location, alleviating the need for constant adjustment

and failed prints due to incorrect height adjustment. The Z-Axis stop is attached to

the back side of the LH Z-Axis motor mount. The stop for the Z-axis is adjustable to

accommodate varying sizes and lengths of hot ends, bed build plates or styles of

extruders/tool heads. The initial starting height when printing is critical to

successful printing, and is covered in further detail in Calibration, Alignment and

Tuning.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

No comments

Revolution 3D Printers INFINITY 3D Specifications Page 19